Fluke FLK-TI-SBC3 Instruction Sheet

Charging Base/Power Supply with Adapters
The Fluke FLK-TI-SBC3 Charging Base/Power Supply with Adapters charges the Fluke
FLK-TI-SBP3 Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3 consists of a
charging base, power supply, and power outlet adapters.
PN 3481481 August 2009
© 2009 Fluke Corporation. All rights reserved. Printed in USA.
All product names are trademarks of their respective companies. Specifications are subject to change without notice.

Safety Information

Use the FLK-TI-SBC3 only as specified in this instruction sheet or other Fluke
product-specific manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3.
FLK-TI-SBC3
A Warning identifies hazardous conditions and actions that could cause bodily harm or
death.
A Caution identifies conditions and actions that could damage the Imager or cause
permanent loss of data.
Instruction Sheet
To avoid injury:
● Do not disassemble or short circuit the battery pack.
● Do not expose the battery pack to temperatures above 50 °C (122 °F).
● Do not incinerate or mutilate the battery pack.
● Use only ac adapters approved by Fluke for the product to charge the battery or
power the product.
Symbol
Conforms to requirements of European Union and European Free Trade Association.
P
Imager connected to battery charger.
"
;
Conforms to relevant Australian standards.
) Conforms to relevant Canadian and US standards
Important information. See manual.
W
Do not dispose of this product as unsorted municipal waste. Go to Fluke's website for
~
recycling information.
W Warning
Table 1. Symbols
Description

Charging the Battery

Before using the battery pack for the first time, charge the battery in the two-bay charging
base for at least two and one-half hours. For complete charging instructions, see the "Ti32,
TiR32 Thermal Imagers User Manual."

Specifications

See Table 2 for the specifications.
Table 2. Specifications
10-15 Vdc 2 A or charge battery pack in Imager with included ac
Battery Charging
adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.
Status Charging LED
off no battery detected
Charging / Power LED solid green charged
blinking green charging
blinking red fault
Dimensions 159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)
Operating Temperature -10 °C to 70 °C (-14 °F to 158 °F)
Storage Temperature -20 °C to 80 °C (-4 °F to 176 °F) without batteries
Humidity Range 10 % to 95 % non-condensing
Power LED
no dc power input
dc power present
na
na