Fluke FLK-TI-SBC3B Instruction Sheet

FLK-TI-SBC3B
Charging Base/Power Supply with Adapters
The Fluke FLK-TI-SBC3B Charging Base/Power Supply with Adapters charges the Fluke
FLK-TI-SBP3B Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3B consists of a
charging base, power supply, and power outlet adapters.
PN 4352179 May 2013
© 2013 Fluke Corporation. All rights reserved.
All product names are trademarks of their respective companies. Specifications are subject to change without notice.

Safety Information

Use the FLK-TI-SBC3B only as specified in this instruction sheet or other Fluke
product-specific manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3B.
A Warning identifies hazardous conditions and procedures that are dangerous to the user.
A Caution identifies conditions and procedures that may cause damage to the Product or
the equipment under test.
Instruction Sheet
To avoid injury:
● Do not disassemble or short circuit the battery pack.
● Do not expose the battery pack to temperatures above 50 °C (122 °F).
● Do not incinerate or mutilate the battery pack.
● Use only ac adapters approved by Fluke for the product to charge the battery or
power the product.
Symbol
Conforms to requirements of European Union and European Free Trade Association.
P
Imager connected to battery charger.
"
Conforms to relevant Australian standards.
;
Conforms to relevant Canadian and US standards
)
Important information. See manual.
W
This product complies with the WEEE Directive (2002/96/EC) marking requirements.
~
The affixed label indicates that you must not discard this electrical/electronic product in
domestic household waste. Product Category: With reference to the equipment types
in the WEEE Directive Annex I, this product is classed as category 9 "Monitoring and
Control Instrumentation" product. Do not dispose of this product as unsorted municipal
waste. Go to Fluke's website for recycling information.
W Warning
Table 1. Symbols
Description
Charging the Battery
Before using the battery pack for the first time, charge the battery in the two-bay charging
base for at least two and one-half hours. For complete charging instructions, see the
Thermal Imagers User Manual.

Specifications

See Table 2 for the specifications.
Table 2. Specifications
10-15 Vdc 2 A or charge battery pack in Imager with included ac
Battery Charging
adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.
Status Charging LED
off no battery detected
Charging / Power LED solid green charged
blinking green charging
blinking red fault
Dimensions 159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)
Operating Temperature -10 °C to 70 °C (-14 °F to 158 °F)
Storage Temperature -20 °C to 80 °C (-4 °F to 176 °F) without batteries
Humidity Range 10 % to 95 % non-condensing
Power LED
no dc power input
dc power present
na
na