Setup Instructions; Inflating Instructions; Emptying And Deflating Pool; Wearing Goggles - Polygroup Summer Waves 3D Manual

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.

Inflating Instructions

CAUTION: Inflate by adult only. DO NOT overinflate, use high pressure air compressor to inflate, or exceed the recommended Design Working Pressure. Inflate with
cold air only.
1. Locate a clean area free of stones or other sharp objects to inflate the pool.
2. Inflate the air chambers following the numbered sequence (if any) slowly with a manual/foot air pump.
The adequate air pressure: make sure the pool is firm to the touch but NOT hard - there should be small folds around the armrests, backrests and/or side edges,
and below the cup holders (if any).
3. Close and press the inflation valves into the unit to get a flat surface.
4. Check regularly to ensure the adequate air pressure during each use, especially on very hot or cold days.
NOTE: This pool has a maximum water fill level marked on the inside wall. Do not overfill; drain to proper level if it has rained.

Emptying And Deflating Pool:

Deflate pool, and push down on the side wall and lift up one side of pool to empty pool water.

Wearing Goggles:

1. Remove protective film from goggles lens before use.
2. Adjust goggles head strap and bridge strap to a proper and comfortable position.
• The head strap is used to hold the goggles in place.
• Tighter is not necessarily better, as this may cause discomfort and marking around the eyes.
• Correct adjustment can be obtained by tensioning the band until a comfortable fit is achieved.
• Correct adjustment of the bridge strap is essential for both comfort and a watertight seal.
3. To avoid water intake, slide the lenses closer together or further apart one notch at a time until the correct fit is obtained.
4. To clear water or to adjust goggles, take a firm grip on the eye cup and tilt the lower edge of the eye cup slightly away from the face.
5. To remove goggles, put thumbs under head strap at side of head. Slide thumbs to back of head, and lift elastic from back to front of head.
6. It is recommended that teachers, coaches, or mature swimmers demonstrate this method to young children.
1
The 3D Goggles must be worn to see the 3D effect inside the pool.
Care Instructions:
1. Rinse goggles with cold tap water before storage.
2. Air-dry goggles, and store in a dry place. Do not store in direct sunlight.
Repair
1. Use a mix of liquid dish soap and water in a spray bottle, and spray over suspicious areas. Any leak will produce bubbles that will pinpoint the location of the leak.
2. Thoroughly clean the area surrounding the leak to remove any dirt or grime.
3. Cut a piece of repair patch (included) with a margin of 0.8" (2cm) larger than the damaged area, rounding the corners with scissors.
4. Place the patch over the center of the leak, press down firmly, and squeeze out all air bubbles to the edges. You may want to put a weight on top to keep it in place.
5. Do not inflate for one hour after patching.
NOTE: if the patch does not hold, you can use the patch with silicone- or polyurethane-based glue designed for repairing camping mats, tents or shoes. Consult
your local household/camping supply stores, and follow the instructions of the glue you've chosen.

SETUP INSTRUCTIONS

2 3
3