Zeutschel OS16000 Manual

Information about Cleaning and Disinfection of your
Zeutschel OS16000, OS15000 and OS12002 Comfort Scanner
1. Recommended cleaning aids
•
Microfiber cloth for screen and device surfaces
•
Mixture of 70% isopropanol and 30% water for all surfaces
We recommend the wearing of disposable gloves when cleaning and disinfecting surfaces.
2. Recommendation for use
•
Switch off device.
•
Unplug device from power supply.
•
Wet a microfiber cloth with a mixture of 70% isopropanol and 30% water. The cloth should
be moist but not dripping wet. If the cloth is wet, you should remove excess moisture before
cleaning the product. Please do not use material other than microfiber cloth, since this may
cause product damages.
•
Wipe the moist cloth carefully over the surfaces to be cleaned.
•
When you clean a screen, wipe carefully in one direction and from top to bottom.
•
The surfaces must completely dried before you switch on again the device after cleaning.
There should be no visible moisture on the surfaces of the product before it is switched on
or plugged in.
•
After cleaning or disinfecting of a glass surface, you can clean it with special display cleaner
in accordance with the instructions for this cleaner. We recommend avoiding glass cleaners
which containing ammonia.
•
Dispose of your disposable gloves after every cleaning process. Clean your hands
immediately after removing the gloves and disposing of the gloves.
3. Must be avoided
•
Never clean a product when it is switched on or connected to the mains!
•
Never spray liquid directly onto the product.
•
Do not use non-recommended liquids.
•
Do not use aggressive liquids.
•
Avoid damaging the device due to improper cleaning.
•
Improper cleaning may destroy electronic and electrical components and cause visual
damage to scanner components.
For that reason:
•
Never clean the scanning system with a jet of water. Do not use any aggressive or abrasive
cleaning aids.
•
Never use steel wool or other aids for tough stains. Always use a soft cloth (e.g. microfiber
cloth) for cleaning.
•
Make sure no liquid can get inside the housing while cleaning.