Advertisement
Advertisement
Related Manuals for Zeutschel OMNISCAN 5000
Summary of Contents for Zeutschel OMNISCAN 5000
- Page 1 OMNISCAN 5000 User‘s Manual TS-194 / 05.01...
-
Page 2: Table Of Contents
TABLE OF CONTENTS TS-194/05.01 Chapter 1: Introduction page Chapter 2: General description page Chapter 3: Safety instructions page Chapter 4: Installation page Chapter 5: Operation page Chapter 6: Maintenance page... -
Page 3: Introduction
Until today, scanning or copying of large books or documents has been cumbersome, time-consuming and inaccurate. With state-of-the-art scan technology ZEUTSCHEL now provides a high performance large format scanning system OMNISCAN 5000 that will efficiently handle books and large documents with high resolution accuracy and reliability. -
Page 4: General Description
Image Enhancement Optional, e.g. contrast enhancement, rotation, Software: de-speckle, de-scew, crop, mask, etc. Book Cradles: Optional, ZEUTSCHEL models OT 180, OT 180 S or OT 90 Power Requirements: 230 V, 50/60 Hz. 400W. Other voltages on request Dimensions: Scanner: 1600 x 900 mm... -
Page 5: Safety Instructions
Safety instructions: The scanner must only be operated with a single-phasing power supply of 230 V/50 Hz with separate protective conductor. Before operation the power supply must be checked by an authorised service engineer. If the local power supply does not meet the above mentioned requirements, please contact the manufacturer who will check if the scanner system can be operated under the existing power supply conditions. -
Page 6: Installation
Install the OS 5000 base unit only on a sturdy, non vibrating table resp. one of the ZEUTSCHEL document tables (OT 180, etc.) for best quality results. The OS 5000 SU is a stand alone version and has to be installed directly on an even non-vibrating floor. - Page 7 Switch-on the scanner OS 5000 COPYSCAN Switch-on the server-pc, while booting the OS 5000 has to identify itself at ID 5 with the name " ZEUTSCH. OMNISCAN 5000". Now install the COPYSCAN software. Please load the first disk in the disk drive "A" and select run a: setup.
- Page 8 OMNISCAN 5000 (1) - power supply and control unit with ON/OFF-switch (2) - server-pc (3) - scan head (4) - top light, left side (5) - top light, right side (6) - push button - camera head up (7) - push button - camera head down...
- Page 9 OT 180/OT 180S/OT 180H or OT 90. Sheets and thin documents can be scanned also with ZEUTSCHEL top light table AT 1 on top of the plate. For detailed instructions we refer to the operation manual of each document table.
-
Page 10: Operation
You can now scan all documents up to size DIN A3 with 400 dpi, up to size DIN A2 (C- size) with 300 dpi resolution.resp. up to size DIN A1 (D-size) with 200 dpi resolution. Documents smaller than the adjusted max. document size can be easily masked with the OS5.x-software (see separate operation manual OS 5.x). -
Page 11: Maintenance
Maintenance: The OMNISCAN 5000 scanner system is built very sturdy, but as every technical product, also the OMNISCAN 5000 requires care and regular maintenance for reliable operation. The following maintenance is recommended: - regular dust cleaning For dust cleaning it is recommended to use a soft leather or glass cleanser.