Mitsubishi Electric MSZ-FT25VG Operating Instructions Manual page 9

I
-SAVE OPERATION
A simplifi ed set back function enables to recall the preferred (preset)
setting with a single push of the
and you can go back to the previous setting in an instance.
1
Press during COOL, CIRCULATOR, HEAT
mode or NIGHT MODE operation to select i-save
mode.
2
Set the temperature, fan speed, and airfl ow direction.
• The same setting is selected from the next time by simply pressing
.
• Two settings can be saved. (One for COOL/CIRCULATOR, one for
HEAT)
• Select the appropriate temperature, fan speed, and airflow direction
according to your room.
Press again to cancel i-save operation.
• i-save operation also is cancelled when the MODE button is pressed.
Note:
Example of use:
1. Low energy mode
Set the temperature 2°C to 3°C warmer in COOL and cooler in HEAT mode.
This setting is suitable for unoccupied room, and while you are sleeping.
2. Saving frequently used settings
Save your preferred setting for COOL, CIRCULATOR, HEAT mode and
NIGHT MODE operation. This enables you to select your preferred setting
with a single push of the button.
button. Press the button again
C
IRCULATOR OPERATION
In case the indoor temperature reaches the setting temperature, the
outdoor unit stops and the indoor unit starts FAN operation to circulate
the indoor air.
The setting of fan speed and airfl ow direction can be changed accord-
ing to your preference.
The outdoor unit starts operation automatically when the indoor tem-
perature drops below the setting temperature.
1
Press during HEAT mode
CIRCULATOR operation.
The unit performs FAN operation in case the indoor temperature reaches
the setting temperature.
2
Set the fan speed and airfl ow direction.
• The setting of fan speed and airflow direction is common for HEAT and
CIRCULATOR operation.
• Ventilation starts at Low fan speed in case AUTO fan speed is se-
lected.
Press again to cancel CIRCULATOR operation.
Note:
CIRCULATOR operation doesn't work in the following situation.
• AUTO mode (Auto change over) is selected.
• Defrosting is being done.
• Indoor unit is connected to multi type outdoor unit.
Although received sound will be heard from the indoor unit and
is displayed on remote controller when
operation doesn't work in multi connection.
• FAN operation may make you feel cold wind.
Reduce the FAN speed or adjust the airflow direction to avoid the wind if you
feel uncomfortable with cold wind.
EN
page 6 to enable
mark
is pushed, CIRCULATOR
EN-8