Adjusting The Governor; Maintenance Schedule; Storage; Short Term Engine Storage (Up To 30 Days) - Champion 200947 Operator's Manual

Walk behind blower
Table of Contents

Advertisement

200947 - WALk BEhiND BLOWER
4. Carefully remove the carbon deposits from the spark arrester
screen with a wire brush.
5. Replace the spark arrester if it is damaged.
6. Position the spark arrestor on the muffler and attach with the
screws removed in step 2.
Failure to clean the spark arrestor will result in degraded
engine performance.
Federal and local laws and administrative requirements
indicate when and where spark arrestors are required. When
ordered, spark arrestors are required for operation of this
blower in National Forest lands. In California, this blower must
not be used on any forest-covered land, brush-covered land, or
grass-covered land unless the engine is equipped with a spark
arrestor.
Always check for fuel leaks before use. A leaking fuel cap is
a hazard and must be replaced immediately. If any leaks are
found, correct the problem before using the product. Failure
to do so could result in a fire hazard that could cause serious
personal injury, including equipment and property damage.

Adjusting the Governor

Tampering or adjusting the factory set carburetor is a Federal
Violation and will void your warranty coverage.
The air-fuel mixture is not adjustable. Tampering with the governor
can damage your blower and will void your warranty. Contact our
Technical Support Team at 1-877-338-0999 for all other service
and/or adjustment needs.

Maintenance Schedule

Follow the service intervals indicated in the following maintenance
schedule.
CAUTiON
NOTiCE
WARNiNG
NOTiCE
Service your blower more frequently when operating in adverse
conditions.
Contact our Technical Support Team at 1-877-338-0999 to locate
the nearest CPE certified service dealer for your blower or engine
maintenance needs.
EVERY 8 hOURS OR DaILY
— Check oil level
— Clean around air intake and muffler
FIRST 5 hOURS
— Change oil
EVERY 50 hOURS OR EVERY SEaSON
— Clean air filter
— Change oil if operating under heavy load or in hot
environments
EVERY 100 hOURS OR EVERY SEaSON
— Change oil
— Clean/adjust spark plug
— Check/adjust valve clearance*
— Clean spark arrestor
— Clean fuel tank and filter*
EVERY 250 hOURS
— Clean combustion chamber*
EVERY 3 YEaRS
— Replace fuel line*
* To be performed by knowledgeable, experienced owners or Champion Power
Equipment certified dealers.

STORAGE

Refer to the Maintenance section for proper cleaning instructions.
1. Allow the blower to cool completely before storage.
2. Turn off the fuel supply at the fuel valve.
3. Clean the blower according to the instructions in the
Maintenance section.
4. Store the unit in a clean, dry area out of direct sunlight.

Short Term Engine Storage (Up to 30 Days)

1. Allow the engine to cool completely before storage.
2. Clean engine according to the Maintenance section.
24
STORAGE

Advertisement

Table of Contents
loading

Table of Contents