Table of Contents
Advertisement
200947 - WALk BEhiND BLOWER
Before inspecting, cleaning, or servicing the blower, shut off
the engine. Wait for all moving parts to stop, disconnect spark
plug wire and move it away from the spark plug. Failure to
follow these instructions could result in personal injury or
damage to the blower.
For emission control devices and systems, read and
understand your responsibilities for service as stated in the
Emission Control Warranty Statement of this manual.
When servicing, use only genuine approved replacement parts.
Use of any other parts could result in poor performance or
damage the blower.
Cleaning the Blower
DO NOT spray engine with water.
Water can contaminate the fuel system and can enter the
engine through the cooling slots and damage the engine.
1. Use a damp cloth to clean exterior surfaces of the blower.
2. Use a soft bristle brush to remove dirt and oil.
3. Use an air compressor (25 PSI) to clear dirt and debris from
the blower.
4. Inspect all air vents and cooling slots to ensure that they are
clean and unobstructed.
Engine Oil Services
Check the engine oil level before each use and after every five
hours of continuous operation. Running the engine when it is low
on oil will quickly ruin the engine. It is recommended that you
change the engine oil after every 10 hours of operation and even
sooner when operating in extremely dirty or dusty conditions.
a. Check the Engine Oil Level
1. Park the blower on a level area and shut off the engine.
2. Clean around the oil dipstick to prevent dirt from falling into
the crankcase.
3. Remove the dipstick and wipe it clean. Reinsert the dipstick
(do not tighten) and remove it. Add oil as needed to bring the
level up to the FULL mark. Wipe the dipstick clean each time
the oil level is checked. Do not overfill.
WARNiNG
NOTiCE
WARNiNG
CAUTiON
4. Tighten dipstick securely.
MAX
B. Changing the Engine Oil
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the blower as a result of failure to follow these
instructions will void your warranty.
The recommended oil type is 10W-30 automotive oil.
Change oil when the engine is warm. Refer to the oil specification
to select the proper grade for your operating environment.
1. Place the blower on a flat, level surface.
2. Clean around the oil drain plug to prevent dirt from falling into
the crankcase. Remove oil drain plug with a 10mm socket
(not included)
22
MAiNTENANCE
OIL DIP STICK
CAUTiON
NOTiCE
DRAIN BOLT
Advertisement
Table of Contents
