Vertical Air Flow Adjustment; Forward Air Flow Attachment - Champion 200947 Operator's Manual

200947 - WALk BEhiND BLOWER

Vertical Air flow Adjustment

The blower is equipped with an adjustable vertical air flow louver.
The vertical air flow can be adjusted to 3 positions: Straight
(level), 15 degrees up and 15 degrees down.
1. Stop the engine (see Stopping the Engine section)
2. Pull the index lever out of its existing hole.
3. Rotate the index lever to the desired position.
4. Release the index lever and allow it to insert into the desired
hole.
15° DOWN
STRAIGHT/LEVEL
15° UP
5. To direct the air flow down 15 degrees, place the index lever
into the top position. To direct the air flow level/straight,
place the index lever into the middle position. To direct the
air flow up 15 degrees, place the index lever into the bottom
position.

forward Air flow Attachment

The blower includes a forward air flow attachment. Assembly of
this attachment to the discharge chute will direct the air flow to
the front of the blower instead of the side.
1. Stop the engine (see Stopping the Engine section).
2. Loosen the attachment knob located on top of the blower
discharge chute.
3. Orient the attachment so "This Side Up for Use" is visible and
the arrows are oriented toward the discharge chute.
4. Slide the attachment over the discharge chute. The slot
on the top of the attachment will mate with the bolt of the
attachment knob.
5. Hand-tighten the attachment knob to secure the attachment.
When not in use, the forward air flow attachment can be stored
under the frame at the rear of the blower.
1. Turn the attachment so "This Side Up for Storage" is visible
and the arrows are oriented towards the storage area.
2. Insert the attachment into frame opening, with the orientation
identified on the label.
3. The edge of the attachment will be supported by a bracket
under the frame.
4. Secure the attachment by forcing it upward and rotating
it so the pin on the frame will insert into the slot on the
attachment.
20
OPERATiON