Table of Contents
Advertisement
200947 - WALk BEhiND BLOWER
ASSEMBLY
Your blower requires some assembly. This unit ships from the
factory without oil. It must be properly serviced with fuel and oil
before operation. For questions regarding the assembly of your
blower, call our help line at 1-877-338-0999. Please have your
serial number and model number available.
Remove the Blower from the Shipping Carton
1. Set the shipping carton on a solid, flat surface.
2. Remove all contents from the carton.
Assemble front Wheel
1. Align the 4 holes on the front wheel bracket with the 4 holes
on the blower frame near the rear wheel on the left side of
the frame (from the user position).
2. Place a lock washer and flat washer onto each M8 × 20 hex
bolt. Thread a M8 × 20 hex bolt into each hole and, using a
13mm wrench, tighten to 15 lbf. ft. - 19 lbf. ft.
(20.3 - 25.8 Nm)
Assemble Upper handle
1. Place the upper handle assembly down over the lower handle
assembly, with the upper handle on the outside, and align the
teeth of the upper handle adjuster so they seat into the teeth
on the lower handle adjuster.
2. From the outside of the handle assembly, insert the threaded
end of the handle adjust lever through the hole on the upper
handle assembly and the hole on the lower handle assembly.
3. Thread a M8 nylon lock nut onto the threaded end of the
handle adjust lever. Holding the handle adjust lever in place,
use a 13mm socket or wrench to tighten the lock nut securely
locking the handle in place. (see operation section for handle
height adjustment).
Assemble Throttle Control
1. Align the throttle control to the outside of the upper left
handle (from the user position) with the groove against the
handle and fast speed towards the front.
2. From the outside of the throttle control, place the M6 × 70
carriage bolt through the hole on the throttle and through the
hole on the handle tube.
3. Thread the M6 nylon lock nut onto the bolt and tighten
securely.
14
ASSEMBLY
Advertisement
Table of Contents
