Eumig Automatic P8 Manual page 13

11
NOTE: Films Hhat have just come back from pro-
cessing will usually wind off as shown in Sketch |
on their first run through the projector. In this par-
ticular case, reverse prajection, described on
page 14, is impossible as the film would not be
wound on to the take-up spool. Only when the film
has been run through ance normally and sub-
seguently rewound will it come off the spool in
suck a way [see Sketch |I) that reverse projectien
is possible,
After !he film has run through the take-up spracket
turn the lever C fully to the leff (Fig. T1). This lacks
the film transport and frees the laops which have
been formed by the autamatic threader. After the
film has finally passed under the film rollers and a
sufficient length has come out at the ofher end,
the motor must be switched off. The end of the film
can now be attached to the take-up spool.
Here we should like to mention the handy EUMIG
400 H. spools. As vou will ses from Fig. 12, spring
tongues are aftached to the cores, and by this
simple means the film is held firm.
Fig.