Projection - Eumig Automatic P8 Manual

13
Projection
The P 8 AUTOMATIC is now ready for proieetion.
Switch on by means of switch E, as deseribed in
"Autematie threading ef the film" en Page 10.
The table lamp connarted to the projiecter will
immediately go out. First determine the desired
sereen picture size by holding the lens by its front
rim and pulling it in or out, hen focus by rofating
the lens to the right or left. Picture size and focus
are, of course, also adjustable during projection.
Adijust the running speed if necessary with the
speed control A (Fig. 16) until all fliker disappears.
NOTE: During the short time taken by the aufa-
matic threading of the film, the projector noise is
slightly louder than during the actual projerfion.
In order to proteet the film, a special geld-glass
heat ubsorbing filter is autematically interposed
between the lamp and the film when the projecter
is switched on, remaining in position until the nor-
mal speed has been reached. This filter is also inter-
posed as soon as the speed drops to belaw 10 fra-
mes per second, If parts of two frames are shown
on the screen, turn knob B until this Fault disappears.
Fig, IT
O 3 6 2
seraan distance in feet
2
TS