Kohler K-702101 Installation Manual page 10

5. Install the Inside Door Panel
CAUTION: Risk of product damage. For the protection of your bath unit, use a drop cloth or similar
material as a protective cover during these steps.
CAUTION: Risk of injury. The door panels are very heavy. Two people should lift them into place.
From outside of the shower, install the inside panel first. Position the panel with the rollers toward
the inside of the shower.
Carefully lift the inside panel up inside the top track and hang the rollers on the inside rail.
Roll the panel back and forth along the track to make sure it operates smoothly. Align the panel
with the showerhead side wall jamb.
If the panel does not operate smoothly, adjustment may be needed. If adjustment is needed, remove
the panel.
NOTE: Moving the rollers to the top hole of the hanger brackets will cause the glass to hang lower.
Moving the rollers to the bottom hole of the hanging brackets will cause the glass to hang higher.
Loosen the roller screw(s) and move the roller to another hole in the hanging bracket. Insert and
tighten the screw(s) and rehang the panel.
6. Install the Outside Panel
CAUTION: Risk of injury. The door panels are very heavy. Two people should lift them into place.
From outside of the shower, install the outside panel. Position the panel with the rollers facing the
outside of the shower/bath.
Carefully lift the door panel up inside of the top track and hang the rollers on the outside rail.
1054858-2-A
Inside
Panel
10
Outside
Panel
Kohler Co.