Important Points; Operating Position - Weed Eater 545186732 Instruction Manual

IMPORTANT POINTS

S Use the minimum throttle speed necessary
to effectively cut hedges for optimal hedge
trimmer performance.
S Never attempt to use this hedge trimmer to
cut hedges that have any branches with a
diameter larger than 7/16".

OPERATING POSITION

Hearing
Protection
STOPPING YOUR ENGINE
To stop the engine, move the ON/OFF
D
switch to the OFF position.
STARTING YOUR ENGINE
Fuel engine. Move at least 10 feet (3 me-
D
ters) away from the fueling site.
Hold the unit on the ground in the starting
D
position as shown. Support unit so the
blade is off of the ground and away from
trees, bushes, onlookers, etc.
HELPFUL TIP
If your engine still does not
start after following these
instructions, please call
1- - 800- - 554- - 6723.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
Throttle Lock
Throttle
Trigger
1. Move the ON/OFF switch to the ON posi-
tion.
2. Engage the throttle lock as follows:
press the throttle lock- -out;
D
squeeze and hold throttle trigger;
D
press and hold throttle lock, then
D
release the throttle trigger
D
NOTE:
the engine starts.
ON
Eye
Protection
3. Slowly press the primer bulb 6 times.
4. Move the choke lever to the FULL CHOKE
position.
Primer Bulb
5. Pull starter rope handle sharply until en-
gine sounds as if it is trying to run, but do
not pull rope more than 6 times.
6. Move the choke lever to the HALF
CHOKE position.
7. Pull starter rope sharply until the engine
runs, but no more than 6 pulls.
NOTE:
(at the HALF CHOKE position), check to make
sure the ON/OFF switch is in the ON position.
Move the choke lever to the FULL CHOKE
position and press the primer bulb 6 times; pull
the starter rope 2 more times. Move the choke
lever to the HALF CHOKE position and pull the
starter rope until the engine runs, but no more
than 6 more pulls. If the engine still doesn't start,
it is probably flooded. Proceed to STARTING A
FLOODED ENGINE.
8. Once the engine starts, allow the engine to
run 10 seconds, then move the choke lever
to the OFF CHOKE position. Allow the unit to
Throttle
run for 30 more seconds at the OFF CHOKE
Lock-out
position before squeezing and releasing the
throttle trigger to release the throttle lock.
NOTE:
the OFF CHOKE position, move the choke le-
ver to the HALF CHOKE position and pull the
rope until the engine runs, but no more than 6
pulls.
STARTING A WARM ENGINE
1. Move the ON/OFF switch to the ON posi-
tion.
2. Slowly press the primer bulb 6 times.
3. Move the choke lever to the HALF
CHOKE position.
4. Engage the throttle lock as directed in
STARTING A COLD ENGINE.
-- 5 --
Keep the throttle lock engaged until
OFF
Switch
Choke
If the engine doesn't start after 6 pulls
If engine dies with the choke lever in
Lever