Würth XP 4 Translation Of The Original Operating Instructions page 12

Power display [6]
The power display comprises ten LEDs that illuminate
in blue or red and are arranged in a circle around
the two concentric charging contacts at the end of
the LED lamp.
Shortly before the power module [3] is di-
■
scharged, the last LED briefly illuminates in red
• The LED lamp must now be charged!
Press the charging contacts:
■
• Battery level display
(in switched off state)
3 e.g. ten illuminated LEDs
• LED lamp is fully charged
• Charging time display (when switched on)
3 The number of illuminated LEDs gives an indica-
tion of the remaining relative light duration of
the current light function
3 Information is also displayed, if a light function
has been selected by touching or pressing the
switch
Use [Fig. I]
Press
Press the on/off switch [2] beyond the pressure
■
point
3 The on/off switch [2] engages with a click
Brief touch
Lightly touch the on/off switch [2]
■
3 The on/off switch [2] does not engage
Long touch
Lightly touch the on/off switch [2] for several
■
seconds
3 The on/off switch [2] does not engage
Light programs and light functions
(Fig. I/5)
By turning the black selector ring [5] a choice can
be made between five different positions (light
programs or switch-on lock).
Switch-on lock (Lock)
In this position, the LED lamp cannot be switched on
either intentionally or accidentally (transport lock).
12
Light program LOW
Press
■
3 LOW POWER (reduced brightness) activated
Brief touch
■
3 Change between LOW POWER (reduced
brightness) and POWER (full brightness)
Renewed press
■
3 LED lamp off
In the switched off state, it is possible to
send light signals of different lengths
and reduced brightness (e.g. to
transmit Morse code) by touching the
on/off switch [2]
Light program ACTION
Press or long touch
■
3 POWER (full brightness) activated
As in the LOW light program you can
also send light signals of different
lengths here even in the switched off
state by touching the on/off switch [2]
but in this case the signals are sent with
full brightness.
Brief touch in the light function POWER
■
3 Change between POWER and DIM
Long touch
■
3 DIM (brightness is changed) activated
3 As soon as the on/off switch [2] is released, the
LED lamp illuminates with the current brightness
• The brightness remains saved in the DIM
function
Disconnection of the light head [1] from the
■
power module
3 The set brightness is reset
The brightness of the DIM function can
be reset at any time as previously
described.
Renewed press
■
3 LED lamp off
Light program SIGNAL
Press or long touch
■
3 SOS function (3 x short flash, 3 x long flash,
3 x short flash) activated