Operating Instructions; Completing The Bicycle Rack; Mounting The U-Shaped Bracket; Mounting The License Plate Holder - EUFAB 11563 Manual

Personal injury or property damage possible due to a damaged bicycle rack.
Damage to the rack, e.g. bent parts, cracks or scratches, prevents the safe operation of the rack.
• Do not mount the bicycle rack if it is damaged in any way.
• Proceed as described in the chapter on Maintenance.
Personal injury or property damage due to loss of the bicycle rack while driving.
A loose or faulty connection between the bicycle rack and trailer tow bar can lead to the detachment of the bicycle rack.
• Replace a defective trailer tow bar.
• Clean the trailer tow bar of dirt, dust and grease.
The general operating permit must be carried in the vehicle when the rack is mounted.

5. Operating instructions

5.1 Completing the bicycle rack

The bicycle rack must be finished. Take all of the components out of the packaging and set them out clearly. Every stage is described and you are shown which
components are required for the assembly of the rack.

5.1.1 Mounting the U-shaped bracket

1 Knob nut M8
2 Washer M8
3 Lock screw M8 x 60
4 U-shaped bracket with frameholder
Place the U-shaped bracket (4) on the fixture sleeves of the bicycle rack and screw firmly into place, using the lock screws (3), washers (2) and knob nuts (1) as
shown on Figures 2 and 3.

5.1.2 Mounting the license plate holder

Remove both cross-headed screws from the rear cross-bracket of the bicycle rack.
Insert the screws into the license plate holder and screw firmly to be bicycle rack as shown in Figure 5. Ensure that the license plate is centred and at the same
height as the lights for the license plate.
The mounting clips (5) for securing the license plate are push-out parts in the holder. Break out two of the clips. Slide the license plate into the holder, then
push the clips into the cut-outs (6) to secure the license plate.
10
Figure 2: Assembly of U-shaped
bracket
Figure 4: License plate holder
Figure 6: Mounting the license plate
Figure 5: Mounting the license plate holder
Figure 1: Assembly material,
U-shaped bracket
Figure 3: Screwing the U-shaped
bracket into place