Programming; 1．Button Definition; 2．Setting Methods - Canature BNT95 Series Operation Manual

BNT95 Series Valve Operation Manual

Programming

1．Button Definition:
"MENU"button:
● Enter or exit the system menu.
● Press and hold the button for 3 seconds to unlock the screen.
"SET/REGEN."button:
● Press this button to select a program or to save the settings.
● Press and hold the button for 3 seconds to initiate a manual regeneration at standby
status.
" /+" and " /-" button:
● Press the button to increase or decrease the value of the settings.
● Press the button to enter the previous or the next menu.
2．Setting Methods:
● Press the"MENU" button to enter and exit the menu.
● Press the " /+" or " /-" button to select a parameter.
● Press the"SET/REGEN." button, the parameter starts flashing.
● Press the " /+" or " /-" button to change the value.
● Press the "SET/REGEN." button to save the setting.
● Press the " /+" or " /-" button to select other parameters.
● Follow the above steps to change other parameters.
● Press the"MENU" button to exit settings.
You can only change the flashing parameters
Program will be back to standby status if any button was not operated in 3 minutes. Without
being operated in 3 minutes, the buttons will be locked.
3．Standby Display:
When power is first supplied, the valve may take up to two minutes to initialize. During this
time, the valve will show:
Do not touch any buttons at this time. When the valve reaches the service position, it will
display:
- 3 -