Canature BNT95 Series Operation Manual page 13

BNT95 Series Valve Operation Manual
‥Water Capacity
This value is the total capacity between regenerations. It is used to determine how
many gallons can be used between regenerations
‥Data Entry
This setting is used to calculate the key regeneration parameters (Capacity, Refill
Time, etc.). These data should be input correctly, wrong data will cause the unit doesn't
work properly.
‥Regen. Cycle
Backwash time controls the length of time for the unit to clean the bed by reversing the
flow of water upwards through the bed and out to the drain.
Brine time controls the length of time for the unit to draw regeneration (brine for
softeners) from the brine tank and slowly rinse the media tank from the top to the bottom.
Rinse time controls the length of time to give the tank a final rinse from the top to the
bottom in order to remove any last traces of the regeneration from the tank.
Refill time controls the length of time which the brine valve will open to refill the brine
tank with water in order to produce the regeneration solution for the next regeneration.
The water accurately measured through the valves brine line flow control to make a
precise quantity of regeneration solution.
Filter Valve only have two cycles: Backwash and Rinse
- 12 -