Page 2
Please read all instructions before starting. leg to the treadle bar on the outside of the Install the wolf stroller on a hard sur- face. Open the loom to weaving position leg 1” from the bottom (figure 1). Remove (see front cover illustration). When you the bolt from the leg.
Page 3
and 2). Using a flat screwdriver to hold the H (on the leg) barrel nut in place, tighten the bolt into the barrel nut. Repeat for the other front caster block. Install the caster blocks to the back legs and the rear leg brace. Remove the truss- head bolt (B) from the back leg and the rear leg brace.
Page 4
DriLLing guiDe temPLate Use a 1/4” drill bit. For Baby Wolf looms with serial numbers lower than 4-1608, 4-4-1609, and 8-546, you will need to drill holes in the front and rear legs using this template. – 4 –...