Replacing The Fuses - Yamaha R6 YZF600 Manual

battery tends to discharge more quick-
ly if the vehicle is equipped with op-
tional electrical accessories.
NOTICE
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional battery
charger will damage the battery.
To store the battery
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure to turn the main
switch off, then disconnect the
negative lead before discon-
necting the positive lead.
2. If the battery will be stored for
more than two months, check it at
least once a month and fully
charge it if necessary.
3. Fully charge the battery before in-
stallation. NOTICE: When install-
ing the battery, be sure to turn
the main switch off, then con-
Periodic maintenance and adjustment
nect the positive lead before
connecting the negative lead.
[ECA16842]
ECA16522 4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
[ECA16304]

Replacing the fuses

The main fuse, the ABS motor fuse,
and fuse box 1 are located under the
rider seat. (See page 4-22.)
TIP
ECA16531
To access the ABS motor fuse, remove
the starter relay cover by pulling it up-
ward.
1. ABS motor fuse
2. Starter relay cover
3. ABS motor spare fuse
4. Main fuse
7-36
EAU2370A
2
1
3
4
7