Sea Breeze PTAC49CH3ZC Installation & Owner's Manual page 9

INSTALLING UNIT INTO WALL SLEEVE
1. Carefully remove shipping tape from the front panel and vent door. See Fig. 9 .
2. Remove shipping screw from the vent door, if present. See Fig. 10.
3. Remove front panel. See Fig. 11.
4. Lift unit level and slide unit into wall sleeve until foam seal rests firmly against front of wall sleeve.
5. Secure with four screws (supplied) through the unit flange holes. See Fig. 12.
6. Reinstall front panel. See Fig. 13.
CAUTION
!
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Failure to remove shipping tape and screw will prevent
fresh air vent door from opening and may result in damage
to vent door cable
Shipping
tape
Fig. 9 - Shipping Tape Location.
Fig. 10 - Shipping Screw Location.
Pull out at the bottom to release it
from the tabs. (1) Then lift up. (2)
Fig. 12 - Securing Unit
Remove
shipping
screw if
present.
Place tabs over top rail (1).
Push inward at bottom until
panel snaps into place (2).
7
Fig. 11 - Removing Front Panel
Fig. 13 - Replacing Front Panel.