Sea Breeze PTAC49CH3ZC Installation & Owner's Manual page 5

UNIT FEATURES CONTINUED
• Unit Configuration – There are many different configuration possibilities, through both dip switches
and the digital keypad. This allows you to configure the unit for your exact application. See section on
unit configuration for more details. Following are the configuration selections that have not been previously
mentioned:
• °F or °C – The unit can display in either °F or °C.
• Indoor Temperature Sensor Biasing – Optimize the room temperature sensor reading to your exact
application (one for cooling and another for heating).
• Emergency Heat (for heat pump only) – Disables the compressor during heating mode operation and heats
with electric heat only.
• Display Set Point or Room Temperature - The unit can be configured to display the room temperature
or set point only during heating and cooling modes. See section on unit configuration for more details.
• Limit the Set Point Range - The unit can be configured to limit the controlling set point range. The
display will always show the complete set point range but the controlling set point will be limited to the
configured minimum and maximum set point selected. See section on unit configuration for more details.
• Energy Management – Sometimes known as Front Desk Control. An input is provided so that the
unit can be manually disabled from a different location. If the unit detects 24 VAC on this input it will
turn itself off. If no voltage is detected on the input the unit will run normally.
• Wall Thermostat Control - An external wall thermostat can be connected to the unit. If connected the
unit must be configured to disable the keypad. See section on wired inputs and unit configuration for
more details.
• Remote Control - Remote control is available by adding a receiver module to the unit. See the 950-0254
installation manual packaged with the remote control and receiver module.
3