Normal Procedures; Definitions; Visual Inspection - THRUSH S2R-T34 Airplane Flight Manual

Thrush Aircraft Inc
Albany, GA

NORMAL PROCEDURES

Subject
DEFINITIONS................................................ II-1
VISUAL INSPECTION.................................. II-2
BEFORE STARTING .................................... II-5
STARTING ENGINE ..................................... II-5
DRY MOTORING RUN ................................ II-6
TAXI ............................................................... II-
BEFORE TAKE-OFF..................................... II-7
TAKE-OFF ..................................................... II-7

DEFINITIONS:

WARNING
CAUTION
NOTE
Airspeeds

VISUAL INSPECTION:

Visually check the aircraft for general condition during the walk around
inspection. Verify that all skin panel Camlocs are fastened. In cold weather
remove all accumulations of frost, ice, or snow from wing, tail and control
surfaces. Check that control surfaces contain no internal accumulations of ice. If
a night flight is planned, check operation of all lights and assure a flashlight is
available.
FAA APPROVED: Apr. 10, 2007
Model S2R-T34
AIRPLANE FLIGHT MANUAL
SECTION II
TABLE OF CONTENTS
page |
7
Personal injury or loss of life could result if the operating procedures
and techniques are not followed carefully.
Damage to equipment could result if the operating procedures and
techniques are not followed carefully.
This is used when it is essential to emphasize an operating procedure or
technique.
All airspeeds in this Section are Indicated Airspeeds (IAS) in
Miles per Hour (MPH), unless otherwise noted.
NOTE
Subject
| CLIMB ..........................................................II-8
| GLIDE AND APPROACH ...........................II-8
| GO AROUND ...............................................II-8
| LANDING .....................................................II-8
| AFTER CLEARING THE RUNWAY..........II-9
| ENGINE SHUTDOWN ................................II-9
| SECURING THE AIRCRAFT......................II-9
SECTION II
NORMAL PROCEDURES
page
Revision 3, SECTION II-1