Advertisement

Montageanleitung (Original) /
Installation Instructions (translation)
RST 20i4/20i5/25i5
Steckverbinder 4-,5-polig
4-/5-pole Connector
Wichtige Information - bitte aufmerksam lesen
Dieses Beiblatt beschreibt die Montage der vier- und fünf-poligen gesis RST-
Steckverbinder. Bitte beachten Sie, dass elektrische Anschlüsse und Installationen
ausschließlich von hierfür ausgebildeten Fachkräften vorgenommen werden dürfen.
- Zusätzliche technische Hinweise unter www.wieland-electric.com
- Beachten Sie die jeweiligen länderspezifischen Installationsvorschriften.
- Bitte beachten Sie die Sicherheitshinweise am Ende des Dokuments.

Important information - please read carefully

This leaflet describes the mounting of the four and five pole gesis RST connectors.
It is intended for use by trained electricians only. Please observe the warnings and
notes.
- Related technical information is available at www.wieland-electric.com
- Please find specific instructions at the end of this document.
- Please note the safety instructions at the end of this document.
Schraub-Anschlüsse /

Screw Connections

Zugentlastung
/ strain relief
Leiter
/ conductor
Abmantellänge y (mm)
/
Dismantling length y (mm)
Abmantellänge y (Doppelanschluss) /
Dismantling length y (splitter connector)
Abisolierlänge x (mm) /
Insulation strip length x (mm)
Abmantellängen und Abisolierlängen (mm) /
Dismantling and Insulation strip lengths (mm)
y
(PE)
Leitermontage /

Wire connection

Verschließen /
Closing
2.
Click!
1.
Doc. # BA000279 - 02/2017 (Rev. E)
Einfach-Anschluss /
Connector
∅ 6...10 / ∅ 10...14
∅ 13...18
PE
N,L
PE
N,L
30
25
55
50
45
40
8
(Leiterquerschnitt
/ conductor cross
section
1,5 ... 4 mm²)
x
N,L
Schraubanschluss:
Antrieb PZ1,
Anzugsmoment
typ. 0,5 Nm
Screw connection:
Drive PZ1,
Tightening torque
typ. 0,5 Nm
Click!
Verschraubung:
Anzugsmoment
typ. 4+1 Nm
Screw connection:
Tightening torque
typ. 4+1 Nm
RST 20i4/20i5/25i5
Wieland Electric GmbH
Brennerstraße 10-14
96052 Bamberg
Tel. +49 (951) 9324-0
Fax +49 (951) 9324-198
Internet: www.wieland-electric.com
Email: info@wieland-electric.com
Öffnen des Steckverbinders /
1.
2.
Detail
detail
Stecken und verriegeln /
Plugging and locking
Optional: Einsetzen der Handentriegelung /
Inserting the manual disconnect
2.
Opening the connector
Sitz der
Handentriegelung
Position of manu-
al disconnect
1.
DE/EN Seite 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RST 20i4 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Wieland RST 20i4

  • Page 1 It is intended for use by trained electricians only. Please observe the warnings and notes. - Related technical information is available at www.wieland-electric.com - Please find specific instructions at the end of this document. - Please note the safety instructions at the end of this document.
  • Page 2 (e.g. do not attach loads to the cable, no free-dangling cable windings etc.). Die Steckverbinder sind nicht zur Stromunterbrechung geeignet. Trennen oder stecken Sie die Verbindung niemals unter Last! The connectors are not suitable for current interrupting. Never connect or disconnect under load! Hotline: Email: BIT.TS@wieland-electric.com  |  Internet: www.gesis.com Tel.: +49 (951) 9324-996  |  Fax: +49 (951) 9326-996    ...

This manual is also suitable for:

Rst 20i5Rst 25i5

Table of Contents