Getting Started - Pretorian n-ABLER PRO Instructions Manual

Refer to Figure 1 for an introduction to the various buttons and features of your n-ABLER PRO.
The LED is used to show which
Flashes Green See Learn Mode
Flashes Red See Learn Mode B
Performs exactly the same function
Double Click: To activate Double Click
If you have decided to have the buzzer on
(see Additional Features and Learn Mode) it
emits a 'beep, beep' to indicate the double
Anti-Tremor: Three settings are available to
compensate for the degree of user tremor.
To activate Anti-Tremor mode press, and
hold, the button. The LED turns orange and
the unit emits a single 'beep' indicating the
Anti-Tremor mode is set at the lowest degree
of compensation. To increase the level of
compensation press and hold the button
again until it emits 'beep' , 'beep' indicating
intermediate level. Press and hold the button
again until it emits 'beep' , 'beep' , 'beep'
indicating the highest degree of compensation.
Pressing and holding the button again turns
off the Anti-Tremor mode denoted by a falling
warbling tone and the Orange LED going off.
Note the anti-tremor setting you have selected
is automatically retained in the memory and
(e.g. if the computer is turned off)
features are active:
Green Drag Lock off
Red Drag Lock on
Orange Anti-Tremor on
Left Mouse Button
as a mouse 'left click'
Double Click and
Anti-Tremor Button
press the button briefly.
click has taken place.
recalled after loss of power

Getting Started

LED
For ease of navigation around documents.
Press the button once to activate, press
Pan Button
the button again to de-activate
n-ABLER PRO
Figure 1