Specifically designed benefit from J-Pad, please take time to around a wide variety of users’ needs, read this booklet. J-Pad is simple to set up and use, but...
Page 2
Apple references to iPad are applicable to any of the products. above Apple products. J-Pad is not suitable for use with Android tablets, iPad (all versions) Apple Macs or personal computers. Please iPod Touch 3rd Generation and later...
Connecting to your iPad Wake up J-Pad by moving the joystick in any direction. The status LED [D] will flash rapidly to indicate that it is not yet paired with an iPad. If the LED does not flash rapidly, please refer to the ‘Connecting your J-Pad to a different iPad’...
General Operating Guide Modes 1 to 4 are configured for use with Voiceover mode. For further details on how to use J-Pad in these modes, please refer to Section 2. Mode 5 is configured for use with Switch Control mode. Please refer to Section 3 when using J-Pad in this mode.
Page 5
Siri. This can be quite where pressing the red button [C] for two seconds useful for users who would benefit from J-Pad. To also launches Siri. A further, brief, press hides Siri. gain access to Siri on an iPad, the user presses and holds the Home button for two seconds.
Page 6
Using J-Pad with Voiceover In modes 1 to 4, J-Pad makes use of the Voiceover feature built into iPad. Voiceover must be enabled on your iPad to take advantage of the features that modes 1 to 4 offer. This section describes how to choose the mode which is most suitable to your needs and how to use J-Pad in your chosen mode.
To re-engage voice prompts, press and distraction. If you do not want them, press and hold the green button [B] once again. hold the green button [B] on J-Pad for three * See also: Disabling Extended Press Features Section...
Page 9
Programming Mode by pressing the switch adapted app access if you wish. If external Feature Button [G] for approximately 2 seconds. The switches are plugged into J-Pad, these take on the unit emits a warbling beep as it enters Programming switch adapted access settings.
Page 10
Using J-Pad with Switch Control When set to mode5, J-Pad makes use of the Switch Control feature built into iPad. Switch Control must be enabled on your iPad to take advantage of the features that mode 5 offers. This section describes how to set up Switch Control on your iPad and how to use J-Pad in mode 5.
Scanning within a Row Once the correct line has been arrived at, press the green button on J-Pad. You can now scan the items on the row by moving the joystick left or right. Launching an App Once you have arrived at the app you would like to run, press the green button again and it will launch.
Warranty Your J-Pad is warranted against defects in manufacture or component failure. The unit is designed for domestic and educational applications. Use outside these areas will invalidate the warranty. Unauthorised repair or modification, mechanical abuse, immersion in any liquid or connection to incompatible equipment will also invalidate the warranty.
Need help?
Do you have a question about the J-Pad and is the answer not in the manual?
Questions and answers