Table of Contents
Advertisement
Preparing the client computers
5
Enter the domain name you are connecting to.
This should be the same as the "Log on to Windows NT domain" value.
6
Enter a description for your computer (optional).
7
Verify that Dial-Up Adapter #2 (VPN Support) is installed.
If you do not have Dial-Up Adapter #2 (VPN Support), you must install it. For instructions, see
"Installing Dial-Up Adapter #2 (VPN Support)" on page 143.
8
Click OK. Click OK to close and save changes to the Network control panel.
9
Restart the machine.
Installing Client for Microsoft Networks
From the Networks dialog box:
1
Click the Configuration tab. Click Add.
2
Select Client. Click Add.
3
Select Microsoft from the list on the left. Select Client for Microsoft Networks
from the list on the right. Click OK.
4
Select Client for Microsoft Networks.
5
Click Properties.
6
Enable the Logon and Restore Network Connections checkbox.
7
Proceed with Step 3 of "Windows 95/98 platform preparation."
Installing Dial-Up Adapter #2 (VPN Support)
1
Click Add.
2
Select Adapter. Click Add.
3
Select Microsoft from the list on the left. Select Dial-Up Adapter from the list on
the right. Click OK.
4
Proceed with Step 8 of "Windows 95/98 platform preparation."
Windows NT platform preparation
Install the 40-bit or 128-bit service pack 4 available from the Microsoft Web site at
http://support.microsoft.com/download/support/mslfiles/NT4MIN4I.EXE. If the
remote host is not eligible for strong encryption, you must install the 40-bit version.
From the Windows NT Desktop of the client computer:
1
Click Start => Settings => Control Panel. Double-click Network.
2
Click the Protocols tab.
3
Click Add.
4
Select Point To Point Tunneling Protocol.
5
Choose the number of VPNs.
Unless a separate host will be connecting to this machine, you need only one VPN.
6
In the Remote Access Setup box, click Add.
7
Select VPN on the left. Select VPN2-RASPPTPM on the right.
8
Click Configure for the newly added device.
User Guide
143
Advertisement
Table of Contents
