The Firebox V100 Model - Watchguard V100 Hardware Manual

CHAPTER 1: Hardware Descriptions
In the event of a power failure, this security appliance, if left
connected to the power source, will automatically restart
itself after electrical power has been restored. You do not
have to press either the Power button on the front or the
power supply switch on the back of the appliance.

The Firebox V100 model

The front panel of the Firebox V100 security appliance con-
tains the features shown in the following illustration.
1 (Public)
0 (Private)
Rx
Tx
Link
Rx
Tx
Link
High Availability
Status LED
Gigabit interfaces
8
appliance if the power goes out, prompting the
appliance to shut itself down properly.
UPS devices from American Power Company
(APC) are currently supported by the Firebox
Vclass power management firmware. Check the
WatchGuard Web site (www.watchguard.com) for
updated information on complete UPS support.
N
Rx
Tx
Link
100 10 100 10
Rx
Tx
Link
HA2 HA1
HA
High Availability
(HA Interface)
Two Gigabit Ethernet interfaces, labeled 0 and 1
(corresponding to Private and Public), act as the
primary conduits through which network traffic
OTE
Console Interface
Ready
Admin
Power LED
Alarm
Ready
Power
Admin
Alarm
Console Reset
Reset port
Vclass