Watchguard V100 Hardware Manual page 20

CHAPTER 1: Hardware Descriptions
The back panel of a Firebox V100 includes the features
shown in the following illustration.l
AC power cord
Do not connect any Firebox Vclass appliance to a source of
power that supplies the wrong voltage. Doing so will damage
the appliance and void the warranty.
10
Ready
Blinks when the appliance is powering up or
powering down. It is steadily lit when the
appliance is ready for network traffic.
Admin
Illuminates when a user or system administrator is
connected to the Firebox Vclass appliance by
means of the Vcontroller or the WatchGuard CLI.
Alarm
Indicates when an alarm is activated. For more
information on alarms, see the Firebox Vclass User
Guide.
Reset Port
Allows you to insert a straight pin or paperclip and
press an internal Reset switch that restarts the
appliance. This is an alternative to unplugging and
replugging the power cord.
Power LED
Indicates whether the appliance has been fully
turned on and is ready for administration or use.
Power supply switch
"UPS" port
N
OTE
Vclass