Watchguard V100 Hardware Manual page 14

CHAPTER 1: Hardware Descriptions
Alarm
Admin
The back panel of a Firebox V10 appliance contains the
interfaces and ports shown in the following illustration.
1 (Public)
0 (Private)
0 (Private) and 1 (Public)
Console
4
Illuminates when certain alarms are triggered. For
more information on alarms, see the Firebox Vclass
User Guide.
Illuminates when a system administrator is
connected to the appliance by means of the
Vcontroller or the WatchGuard CLI.
Console
Two Ethernet interfaces (RJ-45 connectors) labeled
0 and 1, act as the primary data interfaces.
Incorporated into each Ethernet interface are two
indicator lights labeled 10 and 100. These LEDs
indicate the speed of traffic being transmitted.
A single RJ-45 interface permits a direct
workstation-to-appliance connection. You can use
the WatchGuard Command Line Interface (CLI) to
configure and administer this appliance. For more
information about this administrative option, see
the CLI Guide.
Power
Vclass