Table of Contents
Advertisement
Preparation
1. Do not trim barefoot or in open sandals.
Always wear suitable clothing, gloves, and
stout shoes.
2. Before using the machine and after any
impact, check for signs of wear or damage
and repair as necessary
3. Inspect the area to be cut before each use.
Remove all objects such as stones, broken
glass, nails, wire, string etc, which can be
thrown or become entangled in the trimmer
head.
4. Check that the cutting head and cutting line
are fitted correctly.
Use
Avoid accidental starting. Keep your hands
and fingers away from the switch lever while
inspecting, cleaning or carrying out any
maintenance work.
1. Use the trimmer only in daylight or good
artificial light.
2. Avoid operating your trimmer in wet grass,
where feasible.
3. Take care in wet grass, you may lose your
footing.
4. On slopes, be extra careful of your footing
and wear non-slip footwear.
5. Do not walk backwards when trimming , you
could trip.
6. Keep cutting head below waist level.
7. Switch off before pushing the trimmer over
surfaces other than grass.
8. Never operate the trimmer with damaged
guards or without guards in place.
Cable Restraint
1. Form loop in mains cable and push the loop
through the slot. (Fig. A)
2. To secure, pull the cable back through the
slot.(Fig. B)
•
WARNING
Cutting head continues to rotate after the
trimmer has been switched off.
•
WARNING
The use of eye protection is
recommended. Do not lean over the
trimmer guard whilst trimming, objects
may be thrown by the cutting line. Do not
allow cutting head to rest on the ground.
Do not overload your trimmer.
Overloading can be avoided by making
sure the motor speed does not drop
unduly.
Safety Precautions
Starting and Stopping your Mini-Trim
How to trim
9. Never fit metal cutting elements.
10. Keep hands and feet away from the cutting
means at all times and especially when
switching on the motor.
11. Never pick up or carry a trimmer by the
cable.
12. Do not lean over the trimmer guard - objects
may be thrown by the cutting line.
13. Remove the plug from the mains :
-
before leaving the trimmer unattended for
any period;
-
before clearing a blockage;
-
before checking, cleaning or working on the
appliance;
-
if you hit an object. Do not use your trimmer
until you are sure that the entire trimmer is in
a safe operating condition.;
-
if the trimmer starts to vibrate abnormally.
Check immediately. Excessive vibration can
cause injury.
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be
sure the trimmer is in safe working condition.
2. Replace worn or damaged parts for safety.
3. Only use the replacement cutting line
specified for this product.
4. Only use replacement parts and accessories
recommended by Electrolux Outdoor
Products.
5. Inspect and maintain the trimmer regularly.
Any repairs must be carried out by an
authorised repairer.
To start your trimmer
Squeeze the switch lever (C).
To stop your trimmer
Release the switch lever (C).
Disconnect from the mains electricity
supply before attempting any
maintenance or adjustment.
1. Cut with cutting line at an angle using the tip
(D).
2. Swing trimmer in and out of the cutting area
taking small cuts (E).
ENGLISH - 2
Advertisement
Table of Contents
