CRU Dataport Data Portable 350 Installation Manual

Hide thumbs Also See for Data Portable 350:

DataPortable 350 Installation Guide

Step 1

Step 2

Step 4

Step 5 & 6

Step 1. Pull out the rubber plugs from the sides of the enclosure.

Step 2. Remove the top cover of the enclosure

Step 3. Set your hard disk drive to master. Then connect the power and data cables.

Insert the hard drive back in the enclosure. Make sure the side mount holes on

the hard disk drive line up with the holes on the enclosure.

Step 4. Put the top cover back on to the enclosure.

Step 5. Secure the hard drive and the top cover with the screws.

Step 6. Put the rubber plugs back into position.

Table of Contents

Do you have a question about the Data Portable 350 and is the answer not in the manual?

Page 1 DataPortable 350 Installation Guide Step 1. Pull out the rubber plugs from the sides of the enclosure. Step 1 Step 2. Remove the top cover of the enclosure Step 2 Step 3. Set your hard disk drive to master. Then connect the power and data cables. Insert the hard drive back in the enclosure.
Page 2 Setting up the drive for Windows ME/2000/XP or Mac OS 9.x/X Connect the DataPortable 350 to an available USB port. No new drivers are required. The hard disk drive will be found and a window will pop up stating that new hardware has been detected. If the drive has previously been formatted the drive will be accessible through My Computer on PCs and from the desktop on Macs.