First Use - SATA air carbon regulator Operating Instructions Manual

8. First Use

The air regulator is supplied fully assembled and ready for operation. The
SATA air warmer carbon (Art. No. 214759) can be fitted as an option.
Check after unpacking:
■ Air regulator damaged.
■ Scope of supply complete (see chapter5).
8.1. Personalise air regulator.
The air regulator can be personalised with a CCS disk [3-1]. The air regula-
tor is supplied ex works fitted with a red CCS disk [3-2].
■ Pull off the CCS-disk on the air regulator and replace it with a CCS-disk
of a different colour.
8.2. Exchange fastening module on carrying side.
Notice!
The air regulator is supplied ex works with the fastening module fitted to
the air regulator for right-handed operation.
The breathing protection hood connection must always point to the rear.
■ Fold the hood holder [4-3] down.
■ Unscrew the screws [4-2].
■ Change the side for fitting the hood holder and fastening module [4-1].
■ Fasten the hood bracket and the fastening module to the air regulator
with the screws.
■ Insert the SATA filter timer into the space provided on the side of the
hood holder.
8.3. Remove Protect safety cap
The air regulator is supplied ex works with the Protect safety cap [5-2] fitted
to the left adapter plate [5-4] of the belt.
Changing to the right adapter plate
■ Press the release lever [5-1] in.
■ Pull off the protection cap upwards.
■ Slide in the protection cap on the right adapter plate.
■ The safety nose [5-3] engages in the release lever.
8.4. Insert the filter cartridge
Notice!
The filter cartridge is always inserted on the side of the air flow regulator
[2-2].
Operating instructions SATA air carbon regulator
EN
65