Ring Topology - Siemens 7XV5450-0BA00/DD Manual

3.5

Ring Topology

You can cascade several mini star couplers in a ring topology.
To do this, connect the transmitter of channel 1 to the receiver of channel 1 of the next mini star coupler and
then back to the PC/RTU. This creates a ring topology where each mini star coupler has an additional connector
to the protection device. In a ring topology, the signal that is received at the FO1 master channel comes to all
5 optical channels rather than just to 4 channels, such as in a star topology in compatibility mode. This is how
to create an additional optical channel.
FO1 is the master channel, and FO2 to 5 are slave channels in the example in
to connect to the network control center or to other mini star couplers in the ring structure.
NOTE
i
i
Note that the terminal device on the FO1 optical channel (PC or RTU) gets back the data it has received
immediately as an echo in this ring topology.
NOTE
i
i
Redundant centers (2 RTU masters) are not supported when you cascade several mini star couplers in a ring
topology.
[dw_example_ring-topology_with_mini-star-coupler, 1, en_US]
Figure 3-5
(1) The FO1 channel is the master channel.
(2) The FO2 to FO5 channels are slave channels.
The following table shows how you need to adjust the DIP switches for the mini star couplers in the applica-
tion example as per
Mini Star Coupler (Left)
Signal delay = On
9
10 Signal delay = Off
Accessories, Mini Star Coupler, Manual
C53000-G9050-C595-1, Edition 05.2020
Ring Topology Using Mini Star Couplers
Figure 3-5.
On
9 10
Off On
Off
DIP Switch Mini Star Coupler (Right)
S 1/1
S 1/2
S 1/3
Application Examples
3.5 Ring Topology
Figure 3-5. FO1 (T1/R1) is used
On
Off 9 On 10
Off
29