Belt Replacement - Montgomery Ward GIL-39012B Owner's Manual

\
/'/ |
I
-.1
\, ,
.z
wHEEL DRtvE cAsE puLLEy )..
' / /
/ \
-\
TlNi DRTVE BELT
/
TINE DRIVE CASE PULLEY
I
/1
BELT GUTDE ptN
\r
TINE DRIVE
'O'.'*
,,.,}
-
BELI GUIDE
tl8:g!\|rNG R|N-G/
\_- -__--.---IDLER
ARM L|NK
COTTER PIN
Fre . 1 3
l
I
il
BEIT REPLACEMENT
The bells on this tiller.were specificolly designed
ond
enginee.red to provide long, trouble_free service.
lf
belt replocement is requlred, orOe, ine port
number
shown in the ports list section of thii rn6nuot,
ro Oe
sure you hove o belt thot will provide lhe liie
ond
service reguired.
TINE DRIVE BELT
1. Ploce the clutch lever in the neulrol position.
2. Remove the bell guord.
3. Remove the bett guide (Figure t3).
4. Slip the belt off ihe tine drive cose puiley.
5. Remove belt from the engine pulley ond
slip out
befween engine puiley oio ioieior'r.
6. To reploce belt, reverse obove procedure.
Be sure
belt.is on top of tine drive idler prf fey oncl lhe
bell
g-uide pin neor the tine drive iosqiu-iley
fflguie
13).
7. Reodjust belt os ouflined under belt odjustments.
8. Replqce belt guord.
WHEEL ORIVE BELT
1. Remove the tine drive belt per instructions obove.
2. R_emove the retoining ring in the idler orm shoft
(Figure t3).
3. Remove the belt from lhe wheel drive cose puiley.
4. Remove wheel drive pulley by removing reloining
ring ond stiding puildy orindf. (CAUTI6N: Do no-t
toose woodruff key in drive pulley shoff.)
{Figure
r3).
5. Remove cotter pin from idler orm link (Figure i3).
6. Slide idler qrm ossemblies out unlil lhe spocer con
be slid out between the idler ond idler orm. Re.
move belt. To reploce bett reverse oOove pio-
cedure. Be sure bett is turned inside out (wide iide
on puileys) before instoiling in puileys
ffigurat3|
7. Reodjust belt os ouflined under bell odjuslments.
RE TA ININ G RI NG
10