Battery Charging; Battery Installation; Mower Deck Assembly; Deck Caster Wheels Installation - Walker MT Owner's Manual

Assembly Instructions
3. After the battery is filled with electrolyte, replace
the filler caps and charge the battery. Refer to

Battery Charging .

Battery Charging
BATTERIES PRODUCE EXPLOSIVE GASES
Charge the battery in a well-ventilated
area, so that gases produced while charg-
ing can dissipate.
Keep sparks, flames, and smoking mate-
rials away from the battery at all times.
Make sure the battery cap vents are
open after the battery is filled with acid
(check manifold vent on each cap).
Make sure the battery charger is unplug-
ged before connecting or disconnecting
cables to the battery.
1. Charge the battery at 15 amps for 10 minutes.
DO NOT exceed 20 amps maximum recom-
mended charging rate. Charge until specific
gravity is at least 1.250. Total charging time
should not exceed one (1) hour.
2. After charging the battery, adjust the electrolyte
level to the bottom of the vent wells [1/4 to 1/2 in.
(6 to 13 mm) above the plates].
IMPORTANT: DO NOT overfill the battery.
Electrolyte will overflow through the vented caps
onto parts of the machine and WILL result in
severe corrosion.
3. Install battery.

Battery Installation

Install the battery in the mower as shown in Battery
Installation photo. Connect the positive and nega-
tive cables to the proper battery terminal (red cable
and boot connects to the Positive (+) terminal).
Slide the rubber boot up and over the battery post,
making sure it covers the post completely to pre-
vent an electrical short.
DANGER
WARNING
Make sure the battery cap vents are open.
Improper venting of the battery COULD
cause a battery explosion.
Battery Clamp
Secured by
Wing Nut(s)
Battery Installation

Mower Deck Assembly

Deck Caster Wheels Installation

1. Remove the bolt, nut, axle spacer tube, and
spacer washers from each deck caster wheel
fork.
NOTE: Spacer washers are used only when
the optional semi-pneumatic deck wheels (8.25
x 2.75) are installed.
2. Fit the axle spacer tube through the wheel hub,
position the spacer washer on each side of the
hub (if used), and fit the assembly into the wheel
fork.
3. Insert the 3/8-16 x 4-1/2 in. bolt through the
wheel fork with the bolt head to the outside and
install the 3/8-16 in. Keps nut.
4. Tighten the bolt and nut until the axle spacer
tube bottoms against the inside of the wheel
fork (will not turn) while the wheel and spacer
washers (if used) spin freely without binding.
(+) Battery Cable
Connection
17