Dyson supersonic User Manual page 3

If your appliance cuts out,
unplug it from the mains supply
socket and leave to cool.
7. CAUTION: In order to avoid
a hazard due to inadvertent
resetting of the thermal cut-out,
this appliance must not be
supplied through an external
switching device, such as a
timer, or connected to a circuit
that is regularly switched on and
off by the utility company, or
plugged into any socket where
the electrical supply is unstable
or likely to be turned off.
8. When the appliance is used
in a bathroom, unplug it after
use since the proximity of water
presents a hazard even when
the appliance is switched off.
For additional protection when
the appliance is used in a
bathroom, it is recommended
that a Residual Current Device
(RCD), with a residual operating
current not exceeding 30 mA
is installed in the electrical
circuit supplying the bathroom.
Contact a qualified electrical
installer for advice.
9. Do not use the appliance
for any other purpose than
drying hair.
10. Do not handle any part of
the plug or appliance with
wet hands.
4
11. Do not unplug by pulling on
the cable. To unplug, grasp
the plug, not the cable. The
use of an extension cable is
not recommended.
12. Do not stretch the cable or
place the cable under strain.
Keep the cable away from
heated surfaces and do
not wrap the cable around
the appliance.
13. Do not use any lubricants,
cleaning agents, polishes or
air fresheners on any part of
the appliance.
14. Contact the Dyson Helpline
when a service or repair is
required. Do not disassemble
the appliance as incorrect
reassembly may result in an
electric shock or fire.
15. If the appliance is not working
as it should, if it has received
a sharp blow, if it has been
dropped, damaged, left
outdoors, or dropped into
water, do not use and contact
the Dyson Helpline.
The air exit and metal ring may
be hot during use. Allow to cool
before handling.
5