Stereo; Mono - DIGISYNTHETIC DP Series User Manual

2. Use high-quality loudspeaker cables to connect the load to the amplifier's outputs. Do not use shielded cable.
3. Use shielded cables to connect audio sources to the amplifier's inputs. Either balanced or unbalanced wiring can be used
as shown below.(Barrier block input connectors are available with the PM-BB accessories).
1
3
2
INPUT
+

4.1 Stereo

1. Turn down the level controls (fully counterclockwise) and
2. Set the back panel Stereo/Mono switch to Stereo.
3. Connect the input and output cables .
4. Turn on the amplifier and adjust the level for each channel using the front panel level
controls.
4

.2 Mono

Your amplifier's Mono modes provide double the power of the Stereo mode in a single
channel. In Bridge-Mono mode, the outputs are wired for twice the output voltage. In
Parallel-Mono mode, the inputs are paralleled to link the two channels. Bridge-Mono
mode is provided for loads with impedance greater than 4 Ohms. Parallel-Mono mode
should be used with loads of 4 Ohms .
1. Turn down the level controls (fully counterclockwise) and
2. Set the back panel Stereo/Mono switch to Bridge-Mono.
3. Connect the input and output cables.
4. Make sure the load is balanced (neither side shorted to ground) and
black (-)
binding posts.
5. Turn on the amplifier and adjust both level controls.
1. Turn down the level controls (fully counterclockwise) and
Page 6
BALANCED
GND
-
+
FROM
PREAMPLIFIER
-
SHIELD
Parallel-Mono
UNBALANCED
SHIELD
1
3
2
+
PREAMPLIFIER
INPUT
+
SHIELD
Bridge-Mono
Only channel 1 input is used.
FROM
turn off the amplifier.
turn off the amplifier.
do not
turn off the amplifier.
use the