Installation - DIGISYNTHETIC DP Series User Manual

4 Installation

Installation
Always reduce volume by turning level controls fully counterclockwise when either
connecting or disconnecting cables to the amplifier. This reduces the chance of an
audio "spike" that could possibly cause loudspeaker damage.The guidelines below
are provided to help you get your amplifier installed and ready to go quickly and
easily. Be sure to follow the instructions in Sections 2.1 and 2.2 for the selected
mode of operation. Additional information on input sensitivity, load protection and
required AC mains is provided in Section 2.3.
1. Install the amplifier in a standard 19-inch (48.3 cm) rack, or place it on a stable
surface. The mounting dimensions are 19-inch (48.3 cm) wide, 3.5-inch (8.9 cm) tall
and 17.7-inch (44.9 cm) deep behind the mounting surface.
IMPORTANT! ALLOW FOR ADEQUATE VENTILATION.
43.5cm
AIR FLOW AIR FLOW
IMPORTANT: Be sure the back of
the amplifier is supported
AMPLIFIER
(TOP VIEW)
AIR FLOW AIR FLOW
FRONT OF AMPLIFIER
Fig.2.4 Do Not Block Air Flow
Page 5