Accessing Quick (Speed) Dials From Radio Handset; Answering A Call; Answering On A Radio; Auto Answer - Beam SatRADIO RST820 User And Installation Manual

Satellite and radio communications system
Table of Contents

Advertisement

NOTE: Transmission of any DTMF tones will only transmit whilst the
transmit button of the two-way is depressed and there is no other
activity on the Radio channel

Accessing Quick (Speed) Dials from Radio Handset

The quick-dial mechanism can also be used if any of the quick-dial numbers have been
setup in the SatRADIO.
Dial PIN, then a digit between 0->9 then *, to identify the quick dial number.
The quick dials can be programmed only using the Beam Management System when
connected with a PC to the Log port.
The quick dials are accessed in the following way:
1. Ensure the quick dial locations have been programmed in the main satellite terminal
2. Enter the PIN from the handset as per above instructions
3. Once acceptance pips received enter a Quick Dial location digit between 0->9 then *,
obviously only those locations that have been preconfigured can be called in this
manner.
e.g. if you enter your PIN followed by 2 * this would dial the preset Quick Dial
in location 2.

Answering a call

There are two ways of answering a call on the two-way radio, by either using the DTMF
controls on the handheld to accept the call or if you want all incoming calls answered
automatically then this can be configured on the terminal.
If fitted, the Intelligent Handset can be used to answer a call by pressing the OK button.

Answering on a Radio

A RING signal will be intermittently transmitted on the Radio channel and the handheld user
can reply to answer the incoming call by sending a DTMF-0 to answer the incoming call.
Note: The DTMF-0 must be sent in the gap between rings for it to be heard by
SatRADIO.

Auto Answer

The firmware can be set to automatically auto-answer an incoming call as long as the Radio
is ON. This is the default setting.
Note: Auto answer cannot work concurrently with Autodial being ON
Page 16 of 31

Advertisement

Table of Contents
loading

Table of Contents