Technical Data; Appliance Description; Before The First Use; Operation - Kompernass KH 601 Operating Instructions Manual

Technical data

Power consumption :
Mains voltage:

Appliance description

1 Lid
2 Grip
3 Glass pot
4 Control lamp
5 Base
6 Power cable
7 On/Off switch
8 Cleaning brush
9 Brew chamber
0 Water riser pipe
q Sieve

Before the First Use

• Remove all packaging materials from the appliance.
• Carefully rinse all parts of the brewing system
(Brew chamber 9, water riser pipe 0, sieve q)
and the glass pot 3 (see chapter "Cleaning
and Care").
Proceed as follows before the first usage:
1. Take the glass pot 3 from the base 5 and
remove the brew system from the glass pot 3.
2. Fill the glass pot 3 up to the MAX marking with
water, then add a teaspoon of lemon juice (or lemon
concentrate) to it. If lemon juice is not available,
you could add a teabag (or a teaspoon of loose
tea) directly into the water.
3. Close the lid 1 and replace the glass pot 3
onto the base auf 5.
550-650 W
220-240 V ~ 50 Hz
4. Switch the appliance on with the On/Off switch 7.
The control lamp 4 and the On/Off switch 7
light up. Wait until the control lamp 4 goes out.
5. Switch the appliance off with the On/Off switch 7
and then clean the appliance as described in
"Cleaning and Care".
The Tea Maker is now ready for use.

Operation

Warning:
DO NOT put any sugar into the Tea Maker. DO
NOT heat milk in the Tea Maker. This would irrepar-
ably damage the appliance.
Important:
Green tea is not suitable for brewing in the Tea Ma-
ker. The ideal brewing temperature for green teas
lies at around 70°C. At higher brewing temperatu-
res, such as those generated in the Tea Maker, tannic
acids are released. The tea will taste bitter.
1. Remove the glass pot 3 from the base 5.
2. Open the lid 1 and take out the brew system.
Place the brew system on a level and even surface.
3. Fill the glass pot 3 with the required amount of
water. Never fill it beyond the MAX marking,
and never less than up to the MIN marking.
Warning:
To avoid scalds/burns and electric shocks, ensure
that water does not overflow from the glass pot 3.
4. Take hold of the brew system and pull the water
riser pipe 0 with the sieve q upwards.
5. Place the necessary amount of tea or number of
teabags in the brew chamber 9.
Note:
Ensure that no labels or teabag strings remain in the
appliance.
- 3 -