Troubleshooting - Hamilton Beach 53620 Manual

Troubleshooting

Blender fails to start.
• Power Button was not pressed and program not selected.
• Check to see if unit is securely plugged into an electrical outlet of
proper voltage and frequency.
• Check to see if fuse for electrical outlet has blown or if a circuit
breaker has tripped.
Ingredients will not mix properly.
• Add ingredients in the order listed on Personal Blending Jar.
• Check to see if enough liquid has been added to ingredients.
Mixture should be fluid and free-running at all times.
• Solid pieces are too large.
• Blending Jar is too full. Do not fill past MAX (20 oz.) line.
• Cutting Blade Assembly blades are not sharp or are damaged.
Inspect Blending Jar and Cutting Blade Assembly before each use.
Blender smells like it is burning.
• Turn off Blender and allow unit to cool.
• Although motors are tested during the manufacturing process,
heavy use may cause curing of motor windings. The smell may
quickly dissipate after a few heavy uses.
• If smell continues after additional heavy uses, call the provided
Customer Service number.
8
There is grease around bottom of Blending Jar.
• Monitor problem and source. This may indicate an issue with jar
bearings.
• Call the provided Customer Service number if condition persists.
For Model 53625 only:
Power Button is flashing and Blender will not start.
• Either wait 30 seconds and press Power Button again, or unplug
and plug back in. Press Power Button to try again.
• Remove Personal Blending Jar. Press Power Button to turn on.
Press BLEND to run in place for 30 seconds to 1 minute, and
resume blending.
• Remove Personal Blending Jar and shake. Place Jar back on Base
and resume blending.