Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Airmax SilentAir LR50
Summary of Contents for Airmax SilentAir LR50
- Page 1 SilentAir™ LR50 Diaphragm Compressor Maintenance Kit: INSTALLATION INSTRUCTIONS What’s Included: 2 Outer Diaphragms 2 Inner Diaphragms 2 Diaphragm Front Boards 2 Diaphragm Backs Boards 4 Protective Washers Diaphragm Assembly...
- Page 2 Watch the installation video at airmaxeco.com/InstallLR50 Tools Required: • Phillips Screwdriver • Flat Head Screwdriver • 7mm Nut Driver • Small Pick Tool Installation of your LR50 Compressor Maintenance Kit Warning: Always unplug the unit before any maintenance. Step 1 Flip the compressor upside down.
- Page 3 Step 3 Use a Phillips screwdriver to remove the four screws on the top cover plate. Make sure to save the lock washers on the screws. Step 4 Remove the cover and set to the side. Inspect for any dust or wear on the inside of the unit.
- Page 4 Step 7 Remove the outer diaphragm and discard. Step 8 Use a 7mm nut driver to remove the nut on the inner diaphragm. Make sure to keep the nut and lock washer. Remove and discard the diaphragm backboard followed by the inner diaphragm.
- Page 5 Step 10 Apply the protective washer on top of the diaphragm front board. The diaphragm front board is the one with four pegs. Notch Step 11 Align the four pegs up with the four holes inside the inner diaphragm. Align the two lines on the front board to be pointing to the notches on the inner diaphragm.
- Page 6 Step 14 Install the 2 protective washer onto the diaphragm followed by the diaphragm backboard. The backboard should be installed with the curved side facing inward. It can be helpful to tilt the compressor to keep the washer and diaphragm backboard in place.
- Page 7 Step 18 Reinstall the rubber hose and spring clamp. Now that this side is complete, repeat steps 5 thru 17 for the 2 diaphragm before moving on to Step 19. Step 19 After completing both diaphragms, double check to make sure you have proper alignment between the two stators.
- Page 8 Reinstall the top cover. Reinstall the lock nut. Make sure the notch in the top cover lines up with the notch on top of the compressor. THANK YOU FOR CHOOSING: Airmax , Inc. ® Safe, Simple Solutions ™ P.O. Box 38...
Need help?
Do you have a question about the SilentAir LR50 and is the answer not in the manual?
Questions and answers