Table of Contents
Advertisement
Cleaning (do not use any detergent)
Cleaning and Care
1. Unplug the iron before cleaning.
Always place the iron on its heel rest and
allow cooling down. To clean exterior
surfaces, use a damp soft cloth and wipe
dry. Do not use any chemical solvents, as
these will damage the surface.
4. Auto-clean function.
The auto-clean function helps to slow
down scaling and build up in the iron. It is
recommended to perform the auto-clean
function every 4 weeks.
6
2. Cleaning the soleplate.
Do not use scouring pads or harsh
cleaners on the soleplate as these may
damage the surface. To remove burnt
residue, iron over a damp cloth while
the iron is still hot. To clean the soleplate,
simply wipe with a soft damp cloth and
wipe dry.
Auto-clean function for model without
auto-steam function (ESI7304).
Fill the water tank up to 100ml with cold
tap water. Place the iron on its heel rest.
Plug the iron and set the temperature
selector (L) to the MAX position. When
the temperature indicator light (J) turns
green, unplug the iron, and hold it over
a sink, then turn the steam selector (E)
to the auto-clean position and pull out
the button (F). Gently shake over the sink
until all the water is gone. Insert the auto-
clean button (F) back and press until it
clicks. Turn the iron on the MAX setting to
dry the soleplate. Once the temperature
indicator light (J) turns green again,
unplug the iron, let it cool down on its
heel rest and wipe the soleplate with a
dry cloth.
3. Permanent anti-scale cartridge
The permanent anti-scale cartridge
prevents scale from building up into the
soleplate and will help to extend the
life of the iron if the auto-clean function
is performed regularly. This system is
permanent and does not need to be
replaced.
Auto-clean function for model with
auto-steam function (ESI7504).
Fill the water tank up to 100ml with cold
tap water. Place the iron on its heel rest.
Plug the iron and set the temperature
selector (L) to the MAX/autoclean
position. When the temperature indicator
light (J) turns green, unplug the iron,
and hold it over a sink, then pull out
the auto-clean button (F). Gently shake
over the sink until all the water is gone.
Insert the auto-clean button (F) back
and press until it clicks. Turn the iron on
the MAX setting to dry the soleplate.
Once the temperature indicator light (J)
turns green again, unplug the iron, let it
cool down on its heel rest and wipe the
soleplate with a dry cloth.
• A ttention, if the temperature selector
(L) is not on MAX/auto clean position, it
will not be possible to pull out or place
back the auto-clean button (F).
Advertisement
Table of Contents
