Teccpo TAPS22P Manual page 8

The label on your tool may include the following symbols. The symbols and their definitions are as
follows:
V
A
Hz
W
min
or AC
or DC
no
Safety Rules for Laser Lights
The laser light/laser radiation used in the system is Class 2 with maximum 1mW and 650nm
wavelengths. These lasers do not normally present an optical hazard, although staring at the beam
may cause flash blindness.
WARNING : Do not stare directly at the laser beam.
A hazard may exist if you deliberately stare into the beam, please observe all safety rules as follows;
● The laser shall be used and maintained in accordance with the manufacturer's instructions.
● Never aim the beam at any person or an object other than the workpiece.
● The laser beam shall not be deliberately aimed at personnel and shall be prevented from being
directed towards the eye of a person for longer than 0.25s.
● Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces. I.e. wood
or rough coated surfaces are acceptable. Bright shiny reflective sheet steel or the like is not
suitable for laser use as the reflective surface could direct the beam back at the operator.
● Do not change the laser light assembly with a different type. Repairs must be carried out by the
laser manufacturer or an authorized agent.
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure
Technology Creates Power
SAVE THESE INSTRUCTIONS SYMBOLS
Class I Construction (grounded)
Class II Construction (double insulated)
/min or rpm revolutions or reciprocation per minute
SPM Strokes per minute
Read instruction manual before use
Use proper hearing protection
Use proper respiratory protection
volts
amperes
hertz
watts
minutes
Alternating current
Direct current
no load speed
earthing terminal
safety alert symbol
Use proper eye protection
- 06 -