Teccpo TAPS22P Manual page 11

Switching On and Off (see pic. H)
To start the machine
●First push the lock-off button (5) backward.
●Then press the switch trigger (4) and keep it pressed.
●When cut the wood, put the machine on the
workpiece and push it along the wood.
To switch off the machine
●First take out of the machine from workpiece.
●Then release the switch trigger.
Note: For safety reasons, the On/Off switch
cannot be locked; it must remain pressed during
the entire operation.
Laser function (see pic. I)
Note: Laser light can cause severe eye damage.
Never look directly into the laser beam. Do not
point the laser beam at other people or animals,
either directly or through reflective surfaces.
The laser feature on your saw is powered by two
LR44 1.5V button batteries (installed).
The Laser feature clearly shows you an extend-
ed cut-line, even over debris on the work piece.
●Turn it on with the laser light ON/Off switch right
before cutting.
●Turn it off immediately after use to conserve
battery and laser life.
CHANGING THE LASER BATTERIES (see pic. J)
The batteries that operate the laser will have to be replaced after considerable use of the laser.
1. Turn the laser switch off.
2. Remove the laser cover screw.
3. Lift the laser cover off the top of the laser assembly,
4. Remove the two old batteries (17).
DANGER: Never allow the laser beam to shine into a person's eyes, Serious eye damage could
result. Make sure the laser switch is OFF and the laser is NOT pointing toward you while replacing the
laser batteries and when checking the laser function.
5.Replace with two new batteries.
NOTES:
a)Use two 1.5V LR 44 batteries
b)install the batteries with the"+" side (18) of the
batteries facing the rear of the tool
6. Re-install the laser cover and fasten it in place
with the laser cover screw.
Application
The mini plunge saw is a versatile one that allows you to cut many different types of materials. Some
of the materials include
Technology Creates Power
- 09 -
EN
FR
ES