Ordering Software; Spare Parts - oventrop CS-BS-1 WLAN Manual

Problem Solution
The Datalog CS- In order to check if the proxy server settings for the
BS-1 WLAN is Internet browser are correct, proceed as follows:
not found by the
Î Open the Internet browser.
DeviceDiscoveryTool.
Î In the Extras main menu, select the Settings sub-
menu.
Î In the Advanced... main menu, select the Network
submenu.
Î Click the LAN Settings button.
Î Close all windows by clicking OK.
Î Alternatively use the WLAN connection.
Signal strength of the Î Use the device in another location.
WLAN too low.
The S-Bus cable can be extended to up to 50 m.
The status LED is If all network settings are changed, it might occur that
green although no con- the status LED is not able to signal this change.
nection is available.
Î Restart the device.
No connection to Î If the Datalog is connected via WLAN and LAN and
Oventrop-Portal if one of the connection is then disconnected, restart
possible. the device.
Î Use one connection type only.
38
9 Ordering software
For an expense allowance of EUR 20,-, a DVD containing the source code and
the compiler scripts of the open source applications and libraries can be ordered.
Please send your order to:
OVENTROP GmbH & Co. KG
Paul-Oventrop-Straße 1
D-59939 Olsberg
Please name the version number of the firmware in your order. It can be found in
the web interface, main menu About, submenu General, bottom area (e.g.: „1.0
(200805241128")). Per order, only one version number can be named.