Configuring The Remote Access; Changing The Password; Troubleshooting - oventrop CS-BS-1 WLAN Manual

7.17 Configuring the remote access
ATTENTION! third-party access!
When the default remote access password is not changed, third
parties may gain unauthorised access to the controller connected.
Î Do change the remote access password, note it down
and keep it in a suitable place.
The remote access password is required whenever a controller connected to the
Datalog CS-BS-1 WLAN is to be accessed via the Parameterisation Tool.
In order to change the remote access password, proceed as follows:
Î In the Configuration main menu, select the Remote access submenu.
Î On the Bus access over local network tab, in the Local network access
enabled dropdown menu, select Yes.
Î Enter the new password into the Bus password field.
Î On the Remote access over Internet tab, in the Remote access over
the Web portal dropdown menu, select Yes.
Î Click Save configuration.
The default setting for the Bus access and the Remote access over Internet
is Yes.

7.18 Changing the password

In order to change the user password, proceed as follows:
Î In the Configuration main menu, select the Users submenu.
Î Enter the current password into the Password field.
The default password can be found at the back of the housing (Web-interface).
Î Enter the new password into the New password field.
Î Enter the new password into the Confirm new password field.
Î Click Change your password.
36
8

troubleshooting

User password not available
Problem Solution
The user password is When the user password is not available, the Datalog
not available. CS-BS-1 WLAN has to be reset to its factory settings
in order to regain access to the web interface. The pass-
word can be found at the back of the housing (Web-
interface).
Note
If the Datalog CS-BS-1 WLAN is reset to its factory settings, the configu-
ration previously made will be lost.