Key Beeps; Setting The Handset Ringer; Base Unit Ringer; Making Calls - VTech VT-2931 User Manual

BASIC OPERATIONS

KEY BEEPS

Your Handset keys emit a beep as you press them. If you do not want to hear the beep,
do the following while the Handset is not in use (on hook) :
1. Press PROG
2. Press until KEYBEEPS is flashing
3. Press SELECT
4. Press until OFF is flashing
5. Press SELECT
To turn the keybeep feature ON again, repeat steps 1 through 3.
At the fourth step, press
SELECT.
SETTING RINGER
From the Handset
1. Press PROG.
2. Press until RINGER is blinking
3. Press SELECT.
4. Press or
5. Press SELECT.
There are 4 ringer styles. The current setting is displayed.
6. Press or
7. When the desired ringer type is displayed, press SELECT.
L 2

MAKING CALLS

LINE 1 LINE 2
OFF
Alternate Method
1. Dial the phone number, checking the display for accuracy. If you make a mistake, use the
key to backspace.
2. Once you have entered the phone number, press the desired LINE key.
3. Press OFF to end your call.
until ON is flashing, then press
to select LINE1 or LINE2.
to hear the other ring styles OR turn the Handset ringer OFF.
From the Base:
The Base Unit ringer is controlled by switches located on
the right edge of the Base. Each line can be set to OFF,
LOW, or HIGH volume.
From the Handset
1. Press desired LINE key and listen for dial tone.
2. Dial the phone number. The Base Unit will display HAND-
SET IN USE, and the corresponding LINE key will blink.
3. Press OFF to end your call.
:
12