Basic Operations; Area Code Programming - VTech VT-2931 User Manual

BASIC OPERATIONS

SELECT
LINE 1 OFF
2
1
ABC
5
4
GHI JKL
8
7
PQRS TUV
0
TONE OPER
PROG
HOLD
CONF INTERCOM
1. Press PROG.
2. Press until AREA is blinking.
3. Press SELECT.
4. HOME should be blinking. If not, press
5. Press SELECT. ENTER AREA CODE is displayed.
6. Enter 000.
7. Press SELECT and continue below.
You may program up to 5 local area codes. An area code is "local" if you do not dial "1" when
you make calls to that area code. In other words, you make calls to "local" area codes by
dialing 10 digits (area code plus phone number) without a preceding "1". This might include
your own area code.
1. Press PROG.
2. Press until AREA is blinking.
3. Press SELECT.
4. Press until LOCAL is blinking.
Press SELECT.
5. Press until the desired location is blinking (#1.....#5).
6. Press SELECT . ENTER AREA CODE is displayed.
7. Enter a "local" area code.
8. Press SELECT.
9. Press OFF when finished.
NOTE: To replace or edit an existing area code, use the
digits, and enter the desired area code. Press SELECT when done.

AREA CODE PROGRAMMING

To benefit from all the Caller ID features of your
telephone, you must enter your home area code.
LINE 2
If you live in an area where you dial calls within your
own area code by dialing 7 digits (no area code),
follow these steps (with the Handset OFF ):
3
DEF
1. Press PROG.
6
MNO
2. Press
3. Press SELECT.
9
WXYZ
4. HOME should be blinking. If not, press
5. Press SELECT. ENTER AREA CODE is dis-
REDIAL/PAUSE
FLASH
6. Enter your own home area code.
7. Press SELECT.
ALTERNATE METHOD
If you live in an area where all local calls require 10
digits (area code plus phone number, without dialing
"1" first:)
until AREA is blinking.
blinks.
played.
until it blinks.
11
key to delete the existing
until it